You must log in to edit PetroWiki. Help with editing

Content of PetroWiki is intended for personal use only and to supplement, not replace, engineering judgment. SPE disclaims any and all liability for your use of such content. More information


Coalescers

PetroWiki
Jump to navigation Jump to search

Liquid-liquid coalecers are also widely used in oil refining industry to remove traces of contaminants.

Use in separators

For liquid/liquid coalescence in three-phase separators and other separators in which it is desired to have separate liquid outlets for oil/water, plate packs can enhance separation performance by improving the local flow condition and reducing the distance over which drops have to travel to settle. Plate packs also have been installed to promote gas/liquid separation for degassing application.

The Reynolds number of fluid flow in plate pack can be defined as

Vol3 page 024 eq 001.PNG ................(1)

where

ρc = density of the continuous phase, kg/m3 μc = dynamic viscosity of the continuous phase, kg/(m∙s) or N∙s/m2 Vc = mean velocity of the continuous phase, m/s and dh = equivelent diameter of the flow channel.

For a plate pack with a perpendicular gap spacing of dpp, the hydraulic diameter is approximately equal to 2 dpp. Transition to turbulent flow occurs in the Re range of 1,000 to 1,500.

To determine the drop size that can be removed, consider the schematic in Fig. 8 of an oil droplet rising in a waterflow between plates. The distance a drop has to settle is dpp/cos(α), where dpp is the perpendicular spacing of the plate, and α is the inclination angle. For liquids with “nonsticky” solids, the plate spacing and the angle of inclination can be increased to mitigate plugging.


For the plate pack to be effective, the drop must reach the plate before exiting the pack. A ballistic model of the drop results in

Vol3 page 025 eq 001.PNG ................(2)

where

Vr = drop/rise velocity, m/s Vh = horizontal water velocity, m/s L = plate-pack length, m

and

dpp = plate-pack perpendicular gas spacing, m.

For a low-drop Reynolds number, the drop/rise velocity is given by Stokes’ law, which is written as

Vol3 page 025 eq 002.PNG ................(3)

where

ρw = water density, kg/m3 ρo = oil density, kg/m3 μw = water dynamic viscosity, kg/(m∙s) or N∙s/m2 g = gravitational acceleration, 9.81 m/s2

and

Do = drop diameter, cm.

For a higher-drop Reynolds number, a more general form of Eq. 3 can be used. For a given plate-pack geometry and fluid conditions, the minimum drop that can be removed by the plate pack is obtained from Eqs. 2 and 3.

Vol3 page 025 eq 003.PNG ................(4)

For water drops in oil, the water viscosity in Eq. 4 is replaced with the oil viscosity, and the horizontal velocity is that of the oil phase. Typical design drop size removal in plate packs is approximately 50 μm.

Other designs use mesh and matrix packing for liquid/liquid coalescing. However, plugging issues should be addressed when selecting the coalescer. In general, if solids are present in significant quantities, no coalescing internals are installed.


Nomenclature

ρc = continuous phase density, kg/m3
μc = continuous phase dynamic viscosity, kg/(m∙s) or N∙s/m2
Vc = continuous phase velocity, m/s
dh = hydraulic diameter
Vr = drop/rise velocity, m/s
Vh = horizontal water velocity, m/s
L = plate-pack length, m
dpp = plate-pack perpendicular gas spacing, m
ρw = water density, kg/m3
ρo = oil density, kg/m3
μw = water dynamic viscosity, kg/(m∙s) or N∙s/m2
g = gravitational acceleration, 9.81 m/s2
Do = drop diameter, cm

References

Use this section for citation of items referenced in the text to show your sources. [The sources should be available to the reader, i.e., not an internal company document.]

Noteworthy papers in OnePetro

Al-Qahtani, A.A. 2012. Vessel Internal Electrostatic Coalescer technology (VIEC). SPE-156087-MS presented at the SPE International Production and Operations Conference & Exhibition, Doha, Qatar, 14-16 May. http://dx.doi.org/10.2118/156087-MS.

External links

Use this section to provide links to relevant material on websites other than PetroWiki and OnePetro

See also

Oil and gas separators

PEH:Oil and Gas Separators