You must log in to edit PetroWiki. Help with editing

Content of PetroWiki is intended for personal use only and to supplement, not replace, engineering judgment. SPE disclaims any and all liability for your use of such content. More information


Difference between revisions of "AFE: tubulars"

PetroWiki
Jump to navigation Jump to search
 
Line 63: Line 63:
  
 
== External links ==
 
== External links ==
 +
 +
[[Category: 1.1.2 Authority for expenditures (AFE)]]

Revision as of 12:58, 18 November 2014

Casing and tubing costs are significant factors in the well cost that must be properly estimated in the authority for expenditure (AFE). In some cases, they may account for 50 to 60% of the total expenditures. The costs are dependent on well depth, size, grade requirements, and couplings.

Pipe costs

Pipe costs are influenced heavily by several factors. Pipe size is a major consideration. Fig. 1 illustrates cost variations according to pipe size for N-80 grade long-thread and coupling (LTC) pipe that exceeds a burst rating of 5,000 psi in several sizes. Although engineering considerations should have the major impact on the pipe size selection, cost considerations should have some influence.

Costs increase with higher pipe grades. Table 1 shows costs for 40.0-lbm/ft., 9.625-in. pipe with LTC couplings. As in the case of the pipe sizes, however, pipe-grade selection is an engineering decision. Couplings are seldom selected as a result of costs. However, higher-price premium couplings may allow the use of smaller pipe sizes, which will reduce the overall well costs (Table 2).

Casing equipment

Casing (or cementing) accessory equipment is used to accomplish an effective primary cement job. Although the equipment does not have a major impact on well costs, it should be considered. Table 3 shows a typical suite of equipment requirements for running and cementing casing. This equipment would cost approximately U.S. $3,500 for a 7⅝-in. casing string and U.S. $25,000 for a 7⅝-in. liner.

Drive pipe cost

Drive-pipe costs must be calculated for wells that utilize the pipe. The charges vary for pipe sizes and wall thickness. A drive-shoe cost must be included. Typical drive-pipe size and costs are given in Table 4.

References

See also

Authority for expenditures (AFE)

AFE: location preparation

AFE: drilling rig and tools

AFE: drilling fluids

AFE: rental equipment

AFE: cementing

AFE: support services

AFE: transportation

AFE: supervision and administration

AFE: projected drilling time

AFE: wellhead equipment

AFE: completion equipment

PEH:Introduction to Well Planning

Noteworthy papers in OnePetro

External links